Bracket - Trim - Trunk - LH (Remove and Replace)
Correction code 15240102 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the LH mid C-pillar zone bracket. See Bracket - Zone - C-Pillar - Mid - LH (6/7 Seat) (Remove and Replace).
-
Remove the push clips (x4) that attach
the LH trunk side trim carpet to the vehicle, disconnect the connector, and then remove
the carpet from the vehicle.
-
Remove the bolts (x2) and push clip
that attach the LH trunk trim bracket to the vehicle, and then remove the bracket from
the vehicle.Tip: Use of the following tool(s) is recommended:
- T30 socket
Install
-
Position the LH trunk trim bracket
into the vehicle, and then install the bolts (x2) and push clip that attach the bracket
to the vehicle.Tip: Use of the following tool(s) is recommended:
- T30 socket
-
Position the LH trunk side trim carpet
into the vehicle, connect the connector, and then install the push clips (x4) that
attach the carpet to the vehicle.
- Install the LH mid C-pillar zone bracket. See Bracket - Zone - C-Pillar - Mid - LH (6/7 Seat) (Remove and Replace).