21/06/2022 13:35:09

Track - Outer - 2nd Row Seat - LH (6 Seat) (Remove and Replace)

Correction code 13020102 2.04 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all the doors and lower the front windows.
  2. Remove the LH 2nd row seat assembly from the vehicle. See Seat Assembly - 2nd Row - LH (Without 2nd Row Bench Seats) (Remove and Replace).
  3. Remove the LH 2nd row seat slider. See Slider - Seat - 2nd Row - LH (6 Seat) (Remove and Replace).
  4. Disconnect the LH 2nd row seat outer track position sensor electrical connector.
  5. With assistance, position the LH 2nd row seat onto the seat back.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Protect the seat back as necessary.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place weight on the upper portion of seat back.
  6. Remove the nuts (x2) that attach the LH 2nd row seat outer track to the seat assembly, maneuver the track to clear the studs, and then pull the track outward to release the seat track cable.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  7. Drill the pop rivet that attaches the seat track position sensor to the LH 2nd row seat outer track.
    Tip: Use of the following tool(s) is recommended:
    • 4 mm drill bit
  8. Remove the seat track position sensor from the LH 2nd row seat outer track.

Install

  1. Position the seat track position sensor onto the LH 2nd row seat outer track.
  2. Install a new pop rivet that attaches the track position sensor to the LH 2nd row seat outer track.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a 3.9 mm pop rivet.
    Tip: Use of the following tool(s) is recommended:
    • Blind Rivet Tool - 1054713-00-A
  3. Position the LH 2nd row seat outer track onto the seat assembly, maneuver the track to engage the seat track cable, guide the studs into position, and then install the nuts (x2) that attach seat track to the seat assembly.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  4. With assistance, position the LH 2nd row seat upright.
  5. Connect the LH 2nd row seat outer track position sensor electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tuck the connector under the front strip to avoid damage when installing the outer cover.
  6. Install the LH 2nd row seat slider. See Slider - Seat - 2nd Row - LH (6 Seat) (Remove and Replace).
  7. Install the LH 2nd row seat assembly into the vehicle. See Seat Assembly - 2nd Row - LH (Without 2nd Row Bench Seats) (Remove and Replace).
  8. Raise the front windows and close all the doors.