Filter - HEPA (Remove and Replace)
Correction code
18105502
0.60
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
- 2023-07-12: Reorganized the procedure.
- 2025-07-09: Added the underhood storage unit removal/installation steps.
Remove
- Disconnect the LV battery power. See LV Power (Disconnect and Connect).
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
- Remove the wiper module bracket. See Bracket - Wiper Module (Remove and Replace).
- Remove the HEPA filter cover. See Cover - Filter - HEPA (Remove and Replace).
- Release the clips (x2) that attach the HEPA filter to the vehicle.
Install
-
Install the datums (x3) and the clips
(x2) that attach the HEPA filter to the vehicle.
NoteConfirm the air flow direction. Ensure the clips lock and secure the filter into the housing.
- Install the HEPA filter cover. See Cover - Filter - HEPA (Remove and Replace).
- Install the wiper module bracket. See Bracket - Wiper Module (Remove and Replace).
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
- Connect the LV battery power. See LV Power (Disconnect and Connect).