08/09/2022 16:26:13

Lap Pretensioner - 1st Row - LH (Remove and Replace)

Correction code 20101002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Move driver seat forward.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect LV power. See LV Power (Disconnect and Connect).
  4. Remove the driver seat outboard side shield assembly from the driver seat. See Side Shield - Outboard - Driver Seat (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the back rest and cushion adjust switch from the trim assembly after removing the trim from the seat.
  5. Release the safety lock, and then disconnect the LH 1st row lap pretensioner electrical connector.
  6. Remove the bolt that attaches the LH 1st row lap pretensioner to the seat track, and then remove the pretensioner from the vehicle.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Bolt is patched and held in place with a metal clip.
    Tip: Use of the following tool(s) is recommended:
    • T50 socket

Install

  1. Position the LH 1st row lap pretensioner onto the seat track, and then install a new bolt that attaches the pretensioner to the seat track.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the guide pin onto the seat track.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to use the new patch bolt that is included with the new pretensioner.
    Tip: Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the LH 1st row lap pretensioner electrical connector, and then secure the safety lock.
  3. Install the driver seat outboard side shield assembly. See Side Shield - Outboard - Driver Seat (Remove and Replace).
  4. Connect LV power. See LV Power (Disconnect and Connect).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Calibrate the rear doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate to calibrate the rear doors
  7. Move the driver seat to the original position.