2026-07-13

Sensor - Crash Accelerometer - LH (Remove and Replace)

Correction code 20201152 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-06-24: Released new procedure.
  1. Open the LH front door.
  2. Lower the LH front window.
  3. Open the hood.
  4. Power off the vehicle using the touchscreen.
  5. Remove the rear underhood apron.
  6. Disconnect the LV battery connector and First Responder Loop.
  7. Remove the RH underhood apron.
  8. Remove the LH underhood apron.
  9. Remove the front underhood apron.
  10. Remove the underhood storage unit access panel.
  11. Remove the underhood storage unit carpet.
  12. Remove the underhood storage unit from the vehicle.
  13. Disconnect connector from shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, pull red locking tap
  14. Removed bolt from sensor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 10mm, 7Nm
  15. Remove shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab
  16. Install shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab
  17. Install bolt in sensor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 10mm, 7Nm
  18. connect connector to shotgun accelerometer
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, push red locking tap
  19. Install the underhood storage unit.
  20. Install the underhood storage unit carpet.
  21. Install the underhood storage unit access panel.
  22. Install the front underhood apron.
  23. Install the LH underhood apron.
  24. Install the RH underhood apron.
  25. Connect the First Responder Loop and LV battery connector.
  26. Install the rear underhood apron.
  27. Close the hood.
  28. Calibrate LH and RH Falcon Wing doors from center display
    Informational PurposesAn informational icon, calling your attention
    Note
    Calibration required after LV system is powered down > Service > Calibrate Doors > Hold down Calibrate doors until doors cycle > Calibration Complete Message will appear
  29. Raise the LH front window.
  30. Close the LH front door.