17/06/2022 13:02:11

V Bar - Fascia - Front (Remove and Replace)

Correction code 10012512 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Press the brake pedal to turn on drive rails.
  2. Use the touchscreen to set the air suspension ride height to “Very High.”
  3. Use the touchscreen to set the air suspension into "Jack Mode."
  4. Turn the steering wheel fully to the right.
  5. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  7. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  8. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  9. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  10. Remove the front fascia T badge support. See T Badge Support - Fascia - Front (Remove and Replace).
  11. Release the clips (x4) that attach the front fascia V bar from to the T badge support.

Install

  1. Secure the clips (x4) that attach the front fascia V bar onto T badge support.
  2. Install the front fascia T badge support. See T Badge Support - Fascia - Front (Remove and Replace).
  3. Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  4. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  5. Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  6. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  7. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  8. Calibrate the LH and RH rear doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    Hold the upper B-pillar button in the down position to manually calibrate the rear doors.
  9. Use the touchscreen to remove the air suspension from "Jack Mode."
  10. Use the touchscreen to set the air suspension ride height to “Standard.”