07/07/2022 11:35:51

Trim - Side - Trunk - RH (Remove and Replace)

Correction code 15245102 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all the doors and lower the LH front window.
  2. Move the front seats forward.
  3. Fold the 2nd row seats to the down position.
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  6. Remove the RH trunk load floor bracket cover. See Cover - Bracket - Trunk Load Floor - LH (Remove and Replace).
  7. Remove the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  8. Remove the LH and RH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  9. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  10. Remove the push clips (x4) and release the clips (x2) that attach the rear wall load support to the vehicle, and then remove the support from the vehicle.
  11. Remove the RH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  12. Remove the RH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  13. Remove the RH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  14. Release the RH trunk tie down from the RH side trim carpet.
  15. Remove the push clips (x4) that attach the RH trunk side trim to the vehicle, disconnect the electrical connectors (x2), and then remove the side trim from the vehicle.

Install

  1. Position the RH trunk side trim into the vehicle, connect the electrical connectors (x2), and then install the push clips (x4) that attach the side trim to the vehicle.
  2. Secure the RH trunk tie down into the RH side trim carpet.
  3. Install the RH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  4. Install the RH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  5. Install the RH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  6. Position the rear wall load support into the vehicle, and then install the push clips (x4) and secure the clips (x2) that attach the support to the vehicle.
  7. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  8. Install the LH and RH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  9. Install the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  10. Install the RH trunk load floor bracket cover. See Cover - Bracket - Trunk Load Floor - LH (Remove and Replace).
  11. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  12. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  13. Move the 2nd row seats to the original position.
  14. Move the front seats to the original position.
  15. Raise the LH front window and close all the doors.