2026-07-31

Actuator - Latch - Hood (Single Actuator System) (Remove and Replace)

Correction code 113504020.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Actuator - Latch - Hood (Single Actuator System) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the hood actuator and cable assembly to the vehicle
10 Nm (7.4 lbs-ft)
  • Flex head ratchet/flex head torque wrench
  • 10 mm deep socket
 Reuse

Remove

  1. Open the LH front door.
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  3. Release the locking tab, and then disconnect the hood actuator and cable assembly connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the locking tab to disconnect the connector.
  4. Compress the tabs (x2) to release the hood latch actuator and cable from the hood latch assembly.
  5. Remove the bolts (x2) that attach the hood actuator and cable assembly to the vehicle, and then remove the assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • 10 mm deep socket

Install

  1. Install the hood actuator and cable assembly to the vehicle, and then install the bolts (x2) that attach the assembly to the vehicle.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • 10 mm deep socket
  2. Install the hood latch actuator and cable into the double pull single actuator hood latch assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the tabs (x2) are fully engaged onto the hood latch assembly.
  3. Connect the hood actuator and cable assembly connector.
  4. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  5. Raise the LH front window and close the LH front door.