18/07/2022 16:58:07

Trim - Outer - Seat Post - 2nd Row - LH (Remove and Replace)

Correction code 13089302 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH and RH front doors.
  2. Lower the LH and RH front windows.
  3. Open the LH and RH falcon wing doors.
  4. Move the LH and RH front seats forward.
  5. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  6. Release the clips (x8) that attach the RH rear sill panel trim to the vehicle, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Clip pry tool
    • Plastic trim tool
  7. Remove the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  8. With assistance, release the clips (x5) that attach the 2nd row mid floor board to the vehicle, lift the front of the floor board upwards, and then remove the floor board from the vehicle.
  9. Release the clips (x4) that attach the LH 2nd row seat post outer trim to the vehicle, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Plastic trim tool

Install

  1. Position the LH 2nd row seat post outer trim on the vehicle, and then install the clips (x4) that attach the trim to the vehicle.
  2. With assistance, position the 2nd row mid floor board on the vehicle, and then install the clips (x5) that attach the floor board to the vehicle.
  3. Install the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  4. Position the RH rear sill panel trim on the vehicle, and then install the clips (x8) that attach the trim to the vehicle.
  5. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  6. Close the LH and RH falcon wing doors.
  7. Move the LH and RH front seats to original position.
  8. Raise the LH and RH front windows.
  9. Close the LH and RH front doors.