17/06/2022 13:05:21

Bumper Bracket - Front - Rear Door - Upper - LH (Remove and Replace)

Correction code 11339512 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH windows.
  2. Remove the LH upper rear door glass assembly. See Door Glass Assembly - Rear - Upper - LH (Remove and Replace).
  3. Release the tabs (x2) and rubber clips (x2) that attach the LH upper rear door front bumper to the LH upper rear door, and then remove the bumper from the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the top of the bumper over top the tab, and then release the clips.
  4. Remove the bolts (x2) that attach the outer portion of the LH upper rear door front bumper bracket to the LH upper rear door, and then remove the outer portion of the bracket from the door.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10mm socket
  5. Remove the bolt that attaches the inner portion of the LH upper rear door front bumper bracket to the LH upper rear door, and then remove the inner portion of the bracket from the door.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T30 socket

Install

  1. Position the inner portion of the LH upper rear door front bumper bracket into the LH upper rear door, and then install the bolt that attaches the inner portion of the bracket to the door.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Verify installation direction with the guide tabs on the upper portion of the falcon wing door.
    Tip: Use of the following tool(s) is recommended:
    • T30 socket
  2. Position the outer portion of the LH upper rear door front bumper bracket onto the LH upper rear door, and then install the bolts (x2) that attach the outer portion of the bracket to the door.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the tabs are aligned as pictured before rotating the outer bracket assembly onto the inner bracket assembly. Center adjustment and torque to spec as pictured.
    Tip: Use of the following tool(s) is recommended:
    • 10mm socket
  3. Position the LH upper rear door front bumper onto the LH upper rear door, and then install the rubber clips (x2) and secure the tabs (x2) that attach the bumper to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the rubber clips, and then pull bumper over the tabs.
  4. Install the LH upper rear door glass assembly. See Door Glass Assembly - Rear - Upper - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    After the upper glass is installed, check the gap and flush specifications and adjust if necessary. Refer to CVIS for gap and flush specifications.
  5. Raise the LH windows and close the LH front door.