04/09/2024 22:51:46

Tesla Badge - Rear (Remove and Replace)

Correction code 12050702 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-08-29: Added a note to remind that the rear badge is not reusable due to the positioning problem.
  • 1453028-00-A - Badge Removal Kit
  • 1083769-00-A - MX rear T badge fixture
  • 1049517-00-A - Seam roller
Informational PurposesAn informational icon, calling your attention
Note
The badge is not reusable due to the positioning problem. If the badge is removed for any reason, it must be replaced with a new one.

Remove

  1. Cut the badge removal kit wire, and then tie slip knots onto both handles as required.
    Tip: Use of the following tool(s) is recommended:
    • Badge removal kit - 1453028-00-A
    • Scissors
    • Tape measure metric/inch
  2. Starting from the bottom and working upwards, feed the wire back and forth to separate the rear tesla badge from the trunk surface, and then remove the badge from the vehicle.
  3. Use IPA wipes to remove old adhesive residue from the trunk surface area. Allow 1 minute dry time.

Install

  1. Remove the new rear tesla badge front film, install the badge with the rear film on the badge alignment tool, and then perform a dry fit check as required.
    Informational PurposesAn informational icon, calling your attention
    Note
    The badge alignment tool will line up with the rear applique. Use masking tape to secure the front of the badge to the badge alignment tool.
    Tip: Use of the following tool(s) is recommended:
    • Masking tape
    • MX rear T badge fixture - 1083769-00-A
  2. Peel off the adhesive backing film from the rear tesla badge, and then install the badge on the trunk.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not remove the masking tape from the front of the badge.
    Informational PurposesAn informational icon, calling your attention
    Note
    Starting from the bottom and working upwards, apply pressure and allow the badge to fully adhere to the trunk.
  3. Remove the masking tape and the alignment tool from the rear tesla badge.
  4. Install the rear tesla badge front film.
    Informational PurposesAn informational icon, calling your attention
    Note
    Starting from the bottom and working upwards, use a seam roller to apply pressure and allow the badge to fully adhere to the trunk, and then remove the film.
    Tip: Use of the following tool(s) is recommended:
    • Seam roller - 1049517-00-A
  5. Visually inspect the rear tesla badge and verify proper installation. Wipe away any contamination.