23/06/2022 12:31:14

Escutcheon - Seatbelt Anchor - 2nd Row - LH (6 Seat) (Remove and Replace)

Correction code 20056422 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat underbelly trim. See Trim - Underbelly - 2nd Row Seat - LH (6 Seat) (Remove and Replace).
  2. Remove the bolt and nut that attach the LH 2nd row seat belt anchor to the seat frame.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Discard the nut after removal.
    Informational PurposesAn informational icon, calling your attention
    Note
    The seat frame washer will be reused during installation.
    Tip: Use of the following tool(s) is recommended:
    • Torx T45 socket
    • 11/16 combination wrench
    Informational PurposesAn informational icon, calling your attention
    Note
  3. Release the tabs (x4) that attach the LH 2nd row seatbelt anchor escutcheon to the seat cushion assembly, feed the seatbelt through the seat cushion to release it, and then remove the escutcheon from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently pry the tabs while pulling the escutcheon away from the seat cushion.

Install

  1. Feed the LH 2nd row seatbelt through LH 2nd row seatbelt anchor escutcheon, and then route the seat belt harness through the seat back assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not install the seat belt anchor escutcheon to the seat assembly at this time.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the seat belt anchor escutcheon is routed onto the seat belt prior to seat belt anchor being routed through seat cushion.
  2. Install the bolt and new nut that attach the LH 2nd row seat belt anchor to the seat frame.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Reuse the seat frame washer from removal.
    Tip: Use of the following tool(s) is recommended:
    • Torx T45 socket
    • 11/16 combination wrench
    Informational PurposesAn informational icon, calling your attention
    Note
  3. Position the LH 2nd row seatbelt anchor escutcheon into the seat cushion, and then secure the tabs (X4) that attach the escutcheon to the seat cushion.
    Informational PurposesAn informational icon, calling your attention
    Note
    Firmly press the seat belt anchor escutcheon to the seat cushion to secure it.
  4. Install the LH 2nd row seat underbelly trim. See Trim - Underbelly - 2nd Row Seat - LH (6 Seat) (Remove and Replace).