2026-07-06
Seal - Output - Front Drive Unit - LH (Remove and Replace)
Correction code
39300101001
39300101002
FRT
0.00
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components.
- 2026-06-24: Released new procedure.
Remove
- Remove the LH front halfshaft. See Halfshaft - Front Drive Unit - LH (Remove and Replace).
-
Remove the LH front output axle seal
from the front drive unit.
Install
-
Install the LH front output axle seal
into the front drive unit. Verify that the seal is fully seated.
- Install the LH front halfshaft. See Halfshaft - Front Drive Unit - LH (Remove and Replace).