26/06/2023 15:22:25

Side Shield - Inboard - 2nd Row Seat - LH (5 Seat) (Remove and Replace)

Correction code 13085102 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat assembly. See Seat Assembly - 2nd Row - LH (5 Seat) (Remove and Replace).
  2. Move the LH 2nd row seat back to the upright position.
  3. Release the clip that attaches the seat belt buckle harness to the LH 2nd row seat inboard side shield
  4. Pull the LH 2nd row seat inboard side shield away from the seat assembly to release the clips, release the tabs (x2) starting from the bottom, and then lift the side shield upward to release the top edge from the seat frame to remove it from the seat assembly.

Install

  1. Slide the upper tabs on the LH 2nd row seat inboard side shield down onto the seat frame, and then secure the clips and tabs that attach the side shield to the seat assembly.
  2. Secure the clip that attaches the seat belt buckle harness to the LH 2nd row seat inboard side shield
  3. Fold the LH 2nd row seat back to the down position.
  4. Install the LH 2nd row seat assembly. See Seat Assembly - 2nd Row - LH (5 Seat) (Remove and Replace).