Side Shield - Inboard - Driver Seat (Remove and Replace)
Correction code
13041122
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are
created.
NOTE: See Personal Protection to make sure proper PPE is worn
when performing the
below
procedure.
Remove
- Open the LH front door and lower the LH front window.
- Move the driver seat rearwards.
- Open the RH falcon wing door.
-
Carefully release the clips (x7) that
attach the driver seat inboard side shield to the seat assembly.
Install
-
Position the driver seat inboard side
shield onto the seat assembly, and then fasten the clips (x7) that attach the side
shield to the assembly.
- Close the RH falcon wing door.
- Move the drive seat to the original position.
- Raise the LH front window and close the LH front door.