01/04/2024 14:03:55

Sensor - Position - Seat Track - 1st Row Seat - LH (Remove and Replace)

Correction code 13012502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat rearward.
  3. Raise the LH front seat to the highest position.
  4. Disconnect the LH 1st row seat seat track position sensor electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    The sensor is located on the LH front seat inner track.
  5. Remove the screw that attaches the LH 1st row seat seat track position sensor to the seat track, and then remove the sensor from the seat track.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Secure the LH 1st row seat seat track position sensor onto the seat track, and then install the screw that attaches the sensor to the seat track.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    The sensor is located on the LH front seat inner track.
  2. Position the LH 1st row seat seat track position sensor onto the seat track, and then install the screw that attaches the sensor to the seat track.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Connect the LH 1st row seat seat track position sensor electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    The sensor is located on the LH front seat inner track.
  4. Move the driver seat to the original position.
  5. Release the tabs that attach the instrument panel service panel to the vehicle, and then slide the panel rearward to remove it from the vehicle.
  6. Connect a laptop with Toolbox 3 to the vehicle.
  7. In Toolbox, click Actions/Autodiag, and then search for "Calibration".
  8. Click PROC_VCSEATD_SEAT-CALIBRATEvia Toolbox: (link), and then click Run and allow the routine to complete.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure there are no items on the seat during this routine. Click the "X" at the top right of the window to close once complete.
  9. Disconnect Toolbox 3 and remove the laptop from vehicle.
  10. Position the instrument panel service panel into the vehicle, and then slide the panel upward to install it into the vehicle.
  11. Raise the LH front window and close the LH front door.