Cover - Bracket - Trunk Load Floor - LH (Remove and Replace)
Correction code
15305212
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open all the doors and lower the LH front window.
- Move the front seats forward.
- Fold the 2nd row seats to the down position.
- Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
-
Release the clip and tabs (x3) that
attach the LH trunk load floor bracket cover to the vehicle, and then remove the cover
from the vehicle.
Install
-
Position the LH trunk load floor bracket cover into the vehicle, and then secure the
clip and tabs (x3) that attach the cover to the vehicle.
- Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
- Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Move the 2nd row seats to the original position.
- Move the front seats to the original position.
- Raise the LH front window and close all the doors.