23/06/2022 10:04:43

Escutcheon - Seatbelt - 2nd Row - LH (Remove and Replace)

Correction code 20056402 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row recliner lever. See Lever - Recliner - 2nd Row - LH (Remove and Replace).
  2. Remove the LH 2nd row recliner cover. See Cover - Recliner - 2nd Row - LH (Remove and Replace).
  3. Remove and discard the bolt that attaches the LH 2nd row seat belt to the seat assembly.
    45 Nm (33.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx Plus T45P socket
  4. Release the clips (x2) that attach the LH 2nd row seat belt escutcheon to the seat back, and then remove the escutcheon from the seat back.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully pry the escutcheon from the bottom to release it.

Install

  1. Feed the LH 2nd row seat belt through the LH 2nd row seat belt escutcheon, press the top portion of the escutcheon into the seat back, and then secure the clips (x2) that attach the escutcheon to the seat back.
  2. Install a new bolt that attaches the LH 2nd row seat belt to the seat assembly.
    45 Nm (33.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx Plus T45P socket
  3. Install the LH 2nd row recliner cover. See Cover - Recliner - 2nd Row - LH (Remove and Replace).
  4. Install the LH 2nd row recliner lever. See Lever - Recliner - 2nd Row - LH (Remove and Replace).