2023-04-04

Underhood Storage Unit (Remove and Install)

Correction code 15240701 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-04-04: Added check for proper routing of and possible damage to HVIL harness branch.

Torque Specifications

Table 1. Torque Specifications: Underhood Storage Unit (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the underhood storage unit to the vehicle
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • Flex head ratchet/flex head torque wrench
  • 4 in extension
Reuse

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  3. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  4. Remove the underhood storage unit access panel. See Underhood Storage Unit Access Panel (Remove and Replace).
  5. Remove the bolts (x8) that attach the underhood storage unit to the body, and then remove the storage unit from the vehicle.
  6. Inspect the HVIL harness branch of the A/C compressor HV harness.
    1. Make sure that the harness does not rest on the shock tower brace where it crosses over to the connector on the LH shock tower.
      Figure 1. Harness improperly routed over the shock tower brace
    2. Inspect the condition of the HVIL harness that it has not been crushed and insulation worn to expose the bare wire.
      Figure 2. Harness crushed
      Figure 3. Insulation worn
    3. If a wire has been damaged, perform an electrical harness repair as a separate activity. Refer to the Service Documents page for more information.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      CAUTION
      Make sure there is sufficient slack in the repaired harness so that there is no stress in the connector on the LH shock tower.

Install

  1. Make sure that the HVIL harness branch of the A/C compressor HV harness is properly routed away from and does not rest upon the shock tower brace.
    Figure 4. Harness properly routed away from the shock tower brace
  2. Install the underhood storage unit into the vehicle, and then install the bolts (x8) that attach the storage unit to the body.
    5 Nm (3.7 lbs-ft)
  3. Install the underhood storage unit access panel. See Underhood Storage Unit Access Panel (Remove and Replace).
  4. Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  5. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).