Skull Cap - Door Mirror - LH (Remove and Replace)
Correction code
12091702
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
-
Use a plastic trim tool to release LH
door mirror skull cap along the outer edge.
-
Pull up on the LH door mirror skull
cap to release the tabs (x7), and then remove skull cap from the mirror assembly.
Install
-
Position the LH door mirror skull cap
onto the mirror assembly, and then align the tabs (x7).
-
Push down on the LH door mirror skull
cap to install it onto the mirror assembly.
NoteEnsure there are no gaps at the inner perimeter of the skull cap to mirror assembly.