08/09/2022 16:25:52

Duct - Jumper - Inboard - Driver (Remove and Replace

Correction code 18100092 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the front windows.
  2. Move the driver front seat rearward.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect LV power. See LV Power (Disconnect and Connect).
  5. Remove the LH front floor mat.
  6. Remove the driver outboard footwell cover. See Cover - Footwell - Outboard - Driver (Remove and Replace).
  7. Remove the driver inboard footwell cover. See Cover - Footwell - Inboard - Driver (Remove and Replace).
  8. Remove the LH center console side carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).
  9. Remove the driver knee airbag assembly. See Knee Airbag - Driver (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the components from the airbag assembly after the assembly has been removed from the instrument panel.
  10. Release the tab that attaches the driver inboard jumper duct to the HVAC housing, and then remove the duct from the vehicle.

Install

  1. Position the driver inboard jumper duct into the HVAC housing, and then secure the tab that attaches the duct to the HVAC housing.
  2. Install the driver knee airbag assembly. See Knee Airbag - Driver (Remove and Replace).
  3. Install the LH center console side carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).
  4. Install the driver inboard footwell cover. See Cover - Footwell - Inboard - Driver (Remove and Replace).
  5. Install the driver outboard footwell cover. See Cover - Footwell - Outboard - Driver (Remove and Replace).
  6. Install the LH front floor mat.
  7. Connect LV power. See LV Power (Disconnect and Connect).
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  9. Calibrate the rear doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate to calibrate the rear doors
  10. Raise the front windows and close the LH front door.