29/06/2023 22:32:43

Base Bracket - License Plate - Front (Remove and Replace)

Correction code 12070102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-06-30: Added additional steps to the removal and installation procedures for CN vehicles.

Remove

  1. Vehicles in China only: Remove the screws (x2) that secure the license plate bracket from the fascia.
    1 Nm (.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not overtorque the screws.
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
    • PH2 Phillips Screwdriver bit
  2. Release the double-sided tape that attaches the front license plate bracket to the front fascia, and then remove the bracket from the fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Heat the license plate bracket along the double sided tape application area to aid in release.
  3. Use IPA wipes to clean the center area of the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute for the IPA to fully dry.

Install

  1. Partially remove the backing from the front license plate bracket adhesive.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release film outwards.
  2. Position the front license plate bracket onto the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Line up the center indicator on the front of the bracket with the center of the front fascia grille and bottom of the T-badge.
  3. Remove the remaining backing from the double-sided tape.
  4. Press the front license plate bracket onto the front fascia to wet-out the double-sided tape.
  5. Vehicles in China only: Install the screws (x2) that secure the license plate bracket to the fascia.
    1 Nm (.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not overtorque the screws.
    Tip: If the vehicle is not reworked yet, rework the license plate bracket first. See Bracket - License Plate - Front (Rework).
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
    • PH2 Phillips Screwdriver bit