15/08/2023 12:20:19

Carrier - Stanchion - Passive Spoiler - LH (Remove and Replace)

Correction code 12222012 1.80 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
For Europe only: Only technicians who have been trained in working with diisocyanates and have completed all required certification courses are permitted to perform procedures using urethane and other products containing diisocyanates. Proper personal protective equipment (PPE) must be worn when working with products containing diisocyanates.

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Open the liftgate.
  4. Remove the backlight glass. See Backlight Glass (Remove and Install).
  5. Use a marker or masking tape to mark the original location of the LH passive spoiler stanchion carrier on the backlight glass.
    Tip: Use of the following tool(s) is recommended:
    • Marker
    • Masking tape
  6. Carefully remove the LH passive spoiler stanchion carrier from the backlight glass.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool
  7. Use IPA wipes to clean the surface area in preparation for the LH passive spoiler glass stanchion carrier installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute dry time.
    Tip: Use of the following tool(s) is recommended:
    • Battery powered drill - 1126456-00-A
    • Eraser wheel
    • Winged scraper set - 1080601-00-A

Install

  1. Use IPA wipes to clean the urethane path on the backlight glass assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute dry time.
  2. Apply the primer onto the backlight glass assembly.
  3. Prepare the caulking gun and urethane.
    Informational PurposesAn informational icon, calling your attention
    Note
    Opening must be 8 mm wide and 14 mm tall.
    Tip: Use of the following tool(s) is recommended:
    • Caulk and adhesive gun - 1080593-00-A
    • Retractable blade knife
    • Tape measure metric/inch
  4. Apply urethane to the LH passive spoiler glass stanchion carrier.
  5. Remove the back side cover from the adhesive tape, align the LH passive spoiler glass stanchion carrier to the original location marked on the backlight glass, and then apply firm and equal pressure to ensure full adhesion to the glass.
  6. Use IPA wipes to clean and remove excess urethane from the surrounding area of the LH passive spoiler glass stanchion carrier and the backlight glass.
  7. If necessary, remove the masking tape from the original location of the LH passive spoiler stanchion carrier on the backlight glass.
  8. Install the backlight glass. See Backlight Glass (Remove and Install).
  9. Close the liftgate.
  10. Raise the LH front window.
  11. Close the LH front door.