17/06/2022 13:22:15

Floor Panel - Rear - 2nd Row (6 Seat) (Remove and Replace)

Correction code 15303032 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open all 4 doors.
  2. Lower LH and RH front windows.
  3. Move the driver and front passenger seats fully forward.
  4. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  5. Open the liftgate.
  6. Remove the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  7. Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
  8. Open the liftgate.
  9. Move the LH 2nd row seat forward.
  10. Remove the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  11. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  12. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  13. Repeat step 9 through step 12 for the RH side of the vehicle.
  14. With the help of an assistant, release the clips (x2) that attach the front of the 2nd row rear floor panel to the body, and then remove the floor panel from the vehicle.

Install

  1. With the help of an assistant, install the 2nd row rear floor panel to the body, and then fasten the clips (x2) that attach the front of the floor panel to the body.
  2. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  3. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  4. Install the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  5. Move the LH 2nd row seat back to its original position.
  6. Repeat step 2 through step 5 for the RH side of the vehicle.
  7. Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
  8. Remove the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  9. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  10. Restore the driver and front passenger seats back to their original position.