2025-12-19

Sensor - Pressure Tube (Remove and Replace)

Correction code 20202002 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
If LV power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the LV power supply, make sure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.
Informational PurposesAn informational icon, calling your attention
Note
This procedure does not currently apply to North American vehicles.

Installation

  1. Install the pressure sensor tune onto the front bumper beam foam.
  2. Install the front bumper beam foam onto the front bumper beam. See Foam - Bumper Beam - Front (Remove and Replace).
  3. Install the front fascia. See Fascia Assembly - Front (Remove and Install).
  4. Unlock the vehicle gateway, See Gateway (Unlock).
  5. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_RCM_X_SERVICE-TASKSvia Toolbox: (link)via Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ RCM Post Replacement Tasks
    • Safety & Restraints ➜ Safety Testing ➜ RCM Service Tasks
    • Safety & Restraints ➜ Seats ➜ RCM Post Replacement Tasks
    • Safety & Restraints ➜ Airbags ➜ RCM Post Replacement Tasks
    • Safety & Restraints ➜ Safety Testing ➜ RCM Service Tasks
  6. Exit Service Mode.
  7. Raise the LH front window and close the LH front door.