22/12/2022 14:53:20

Bracket - Racetrack - C-Pillar - Upper - LH (Remove and Replace)

Correction code 15188102 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all the doors and lower the LH front window.
  2. Move the front seats forward.
  3. Fold the 2nd row seat backs to the down position.
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  6. Remove rear trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  7. Remove LH trunk side mini nub
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, 3x tabs
  8. Remove the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace)
  9. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  10. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  11. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  12. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  13. Remove the LH coat hook bezel.
  14. Release the clips (x7) that attach the rear of the LH rear portion of the headliner to the vehicle.
  15. Remove the screw and release clips (x20) that attach the LH C-pillar rear racetrack trim to the vehicle, and then remove the trim from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  16. Remove the bolts (x2) that attach the LH upper C-pillar racetrack bracket to the vehicle, and then remove the bracket from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • T25 socket
    • T30 socket

Install

  1. Position the LH upper C-pillar racetrack bracket into the vehicle, and then install the bolts (x2) that attach the bracket to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • T25 socket
    • T30 socket
  2. Position the LH C-pillar rear racetrack trim into the vehicle, and then install the screw and secure clips (x20) that attach the trim to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  3. Secure the clips (x7) that attach the rear of the LH rear portion of the headliner to the vehicle.
  4. Install the LH coat hook bezel.
  5. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  6. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  7. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  8. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  9. Install the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  10. Position the LH trunk side mini nub into the vehicle, and then secure the clip and tabs (x3) that attach the trim to the vehicle.
  11. Install rear trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  12. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  13. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  14. Move all the seats back to the original positions.
  15. Close all the doors and raise the LH front window.