Seal - Inner Belt - Front Door - LH (Remove and Replace)
Correction code
11703202
0.30
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
- Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
-
Remove the LH front door outer belt
molding.
-
Use a clip prytool to release the push
clips (x8) that attach the LH front door inner belt seal to the LH front door assembly,
pull up to release the tab, and then pull the RH side of the seal away from the door
panel to remove the seal from the vehicle.
Install
-
Remove the adhesive backing from the
LH front door inner belt seal, position the seal onto the LH front door, and then secure
the clips (x8) and tab that attach the seal to the door.
Note8x push clips, 1x tab, Peel sway adhesive tape
-
Install the LH front door outer belt molding.
- Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
- Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
- Calibrate the windows. See Window Regulator (Recalibrate).
- Confirm that the window operates correctly and without any abnormal noise.