23/06/2022 08:38:46

Crush Plastic - Rear - 3rd Row - LH (Remove and Replace)

Correction code 13066102 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the 3rd row seat assembly from the vehicle. See Seat Assembly - 3rd Row (Remove and Replace).
  2. Lay the 3rd row seat assembly down on a protected surface.
  3. Remove the clips (x2) that attach the LH 3rd row rear crush plastic to the seat assembly, and then remove the crush plastic from the assembly.

Install

  1. Position the LH 3rd row rear crush plastic into the seat assembly, and then install the clips (x2) that attach the crush plastic to the assembly.
  2. Install the 3rd row seat assembly into the vehicle. See Seat Assembly - 3rd Row (Remove and Replace).