12/07/2022 12:49:01

Floor Panel - Rear - 2nd Row (5 Seat) (Remove and Replace)

Correction code 15303042 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH and RH front doors.
  2. Lower the LH and RH front windows.
  3. Open the LH and RH falcon wing doors.
  4. Open the liftgate.
  5. Move the LH front seat forward.
  6. Fold the 2nd row 60 seat downwards.
  7. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  8. Move the RH front seat forward.
  9. Fold the 2nd row 40 seat downwards.
  10. Release the clips (x8) that attach the RH rear sill panel trim to the body, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Clip pry tool
    • Plastic trim tool
  11. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  12. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  13. Remove the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  14. Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (5 Seat) (Remove and Replace).
  15. Lift the front of the 2nd row rear floor panel upwards to release the clips (x2) that attach the panel to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Clip pry tool
  16. Lift the rear of the 2nd row rear floor panel, slide the panel out from behind the seats, and then remove the panel from the vehicle.

Install

  1. Position the 2nd row rear floor panel on the vehicle, and then install the clips (x2) that secure the panel to the vehicle.
  2. Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (5 Seat) (Remove and Replace).
  3. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  4. Move the LH front seat to original position.
  5. Position the RH rear sill panel trim on the vehicle, and then install the clips (x8) that attach the trim to the body.
  6. Move the RH front seat to original position.
  7. Install the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  8. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  9. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  10. Close the liftgate.
  11. Unfold the 2nd row 60 seat to original position.
  12. Unfold the 2nd row 40 seat to original position.
  13. Close the LH and RH falcon wing doors.
  14. Raise the LH and RH front windows.
  15. Close the LH and RH front doors.