Shield - Dust - Brake - Rear - LH (Remove and Replace)
Correction code
33011802
0.90
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift.
- Release the LH park brake caliper through Toolbox. See Park Brake Caliper - Release.
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
- Remove the LH rear hub. See Hub - Rear - LH (Remove and Replace).
-
Remove the bolts (x3) that attach the
LH rear brake shield to the knuckle, and then remove the shield from the vehicle.8 Nm (5.9 lbs-ft)NoteUse of the following tool(s) is recommended:
- Torx T30 socket
Install
-
Install the bolts (x3) that attach the
LH rear brake shield to the knuckle.8 Nm (5.9 lbs-ft)NoteUse of the following tool(s) is recommended:
- Torx T30 socket
- Install the LH rear hub. See Hub - Rear - LH (Remove and Replace).
- Install the LH rear wheel. See Wheel Assembly (Remove and Install).
- Hold the brake pedal and shift into Park on the touchscreen to disable EPB service mode.