Sensor - Air Temperature - Duct - Defrost (Remove and Replace)
Correction code
18109302
1.32
NOTE: Unless otherwise explicitly
stated in the procedure, the correction code and its associated FRT reflect all of the
work required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are
created.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
-
Remove the instrument panel
sub-assembly from the vehicle. See Sub Assembly - Instrument Panel (Remove and Replace).
NoteIt is not necessary to remove components from the sub-assembly after the entire assembly has been removed from the instrument panel.
- Remove the driver instrument panel duct. See Duct - Instrument Panel - Driver (Remove and Replace).
-
Disconnect the defrost duct air
temperature sensor electrical connector, and then remove the sensor from the
vehicle.
Install
-
Position the defrost duct air
temperature sensor into the vehicle, connect the electrical connector, and then install
the sensor into the HVAC case.
NoteConnect the connector before installing the sensor into the vehicle.NoteMake sure the sensor is fully seated into the HVAC case.
- Install the driver instrument panel duct. See Duct - Instrument Panel - Driver (Remove and Replace).
- Install the instrument panel sub-assembly into the vehicle. See Sub Assembly - Instrument Panel (Remove and Replace).