23/06/2022 10:43:50

Escutcheon - Seatbelt - 2nd Row - LH (6 Seat) (Remove and Replace)

Correction code 20056412 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat seat back cover. See Cover - Seat Back - 2nd Row Seat - LH (6 Seat) (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the easy entry switch from the seat back cover.
  2. Disconnect the LH 2nd row seat OBSB heat pad electrical connector.
  3. Release the clip that attaches the LH 2nd row seat OBSB heat pad electrical connector to the seat assembly.
  4. Remove the bolts (x4) that attach the LH 2nd row seat back cushion to the seat back frame.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
  5. Release the Velcro strips (x3), and then lift the LH 2nd row seat back cushion up and forward to release it from the seat back frame.
  6. Remove the screws (x3) that attach the LH 2nd row seatbelt escutcheon to the seat back cushion.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH2 screwdriver
  7. Pull the LH 2nd row seatbelt escutcheon away from the seat back cushion to release it, and then slide the seatbelt through the escutcheon to remove it from the assembly.

Install

  1. Feed the LH 2nd row seatbelt through the LH 2nd row seatbelt escutcheon, position the escutcheon into the seat back cushion, and then install the screws (x3) that attach the escutcheon to the seat back cushion.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH2 screwdriver
  2. Lift the LH 2nd row seat back cushion up and onto the seat back frame, and then secure the Velcro strips (x3) that attach the cushion to the frame.
  3. Install the bolts (x4) that attach the LH 2nd row seat back cushion to the seat back frame.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
  4. Secure the clip that attaches the LH 2nd row seat OBSB heat pad electrical connector to the seat assembly.
  5. Connect the LH 2nd row seat OBSB heat pad electrical connector.
  6. Install the LH 2nd row seat back cover. See Cover - Seat Back - 2nd Row Seat - LH (6 Seat) (Remove and Replace).