17/06/2022 13:11:15

Light - Under Seat - Driver (Remove and Replace)

Correction code 13019302 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH rear door.
  2. Remove the driver seat. See Seat Assembly - 1st Row - LH (Remove and Install).
  3. With assistance, place the driver seat on a protected surface so that the underside of the seat can be accessed.
  4. Disconnect the driver under seat light electrical connector.
  5. Release the locking tab, and then remove the driver under seat under light from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the locking tab and slide the light towards the front of the LH seat rail. Lift the opposite end of the light to remove it from the assembly.

Install

  1. Install the driver under seat light onto the seat assembly, and then engage the locking tab.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the light towards the front of the LH seat rail. Position the opposite end, and then slide the light towards the rear of the driver seat rail to engage the locking tab.
  2. Connect the driver under seat light electrical connector.
  3. Install the driver seat. See Seat Assembly - 1st Row - LH (Remove and Install).
  4. Close the LH rear door.