10/08/2022 11:23:35

Buckle - 3rd Row (Remove and Replace)

Correction code 20058902 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH falcon wing door.
  2. Open the liftgate.
  3. Fold the 2nd row 40 and 60 seats downward.
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the rear trunk floor NVH insulator. See NVH Insulator - Floor - Rear Trunk (Remove and Replace).
  6. Remove the rear trunk carpet. See Carpet - Rear Trunk (7 Seat) (Remove and Replace).
  7. Disconnect the 3rd row buckle connectors (x2).
  8. Remove the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).
  9. Remove the center 3rd row recliner cover. See Cover - Recliner - 3rd Row - Center (Remove and Replace).
  10. Remove and discard the bolt that attaches the 3rd row buckle to the seat frame, and then remove the buckle from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 3 in extension
    • 14 mm socket
    • Ratchet/torque wrench

Install

  1. Position the 3rd row buckle on the vehicle, and then install a new bolt that attaches the buckle to the seat frame.
    45 Nm (33.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 3 in extension
    • 14 mm socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  2. Install the center 3rd row recliner cover. See Cover - Recliner - 3rd Row - Center (Remove and Replace).
  3. Install the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).
  4. Connect the 3rd row buckle connectors (x2).
  5. Install the rear trunk carpet. See Carpet - Rear Trunk (7 Seat) (Remove and Replace).
  6. Install the rear trunk floor NVH insulator. See NVH Insulator - Floor - Rear Trunk (Remove and Replace).
  7. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  8. Close the liftgate.
  9. Unfold the 2nd row 40 and 60 seats into original position.
  10. Close the LH falcon wing door.