17/06/2022 13:21:58

Bracket - 2nd Row Floor Panel - RH (7 Seat) (Remove and Replace)

Correction code 153037320.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open all four doors.
  2. Lower LH front window.
  3. Move the driver and front passenger seats fully forward.
  4. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  5. Move the LH and RH 2nd row seats fully backwards.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use the easy entry switch to unlatch the seats and move them fully backwards. Latch the seatback to lock into position.
  6. Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (7 Seat) (Remove and Replace).
  7. Remove the RH 2nd row seat inboard front floor plate. See Front Floor Plate - Inboard - 2nd Row Seat - LH (7 Seat) (Remove and Replace).
  8. Remove the RH 2nd row seat outboard front floor plate. See Front Floor Plate - Outboard - 2nd Row Seat - LH (7 Seat) (Remove and Replace).
  9. Release the tabs (x2) that attach the seat inline electrical harness bracket to the RH 2nd row panel bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the bracket upward.
  10. Remove the bolts (x2) that attach the bracket to the body, and then remove the bracket from the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm 12-point socket

Install

  1. Install the bolts (x2) that attach the 2nd row floor panel bracket to the body.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm 12-point socket
  2. Fasten the inline electrical harness into the RH 2nd row floor panel bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    x2 tabs
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the tabs downward to engage.
  3. Install the RH 2nd row seat outboard front floor plate. See Front Floor Plate - Outboard - 2nd Row Seat - LH (7 Seat) (Remove and Replace).
  4. Remove the RH 2nd row seat inboard front floor plate. See Front Floor Plate - Inboard - 2nd Row Seat - LH (7 Seat) (Remove and Replace).
  5. Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (7 Seat) (Remove and Replace).
  6. Install the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  7. Restore the 2nd row seats back to their original position.