29/12/2022 13:26:55

Bracket - Zone - C-Pillar - Mid - LH (6/7 Seat) (Remove and Replace)

15186622 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door.
  2. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  3. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  4. Remove the side trunk load floor. See Trunk Load Floor - Side (Remove and Replace)
  5. Remove the trunk tub floor insulator.
  6. Remove the trunk carpet.
  7. Remove the LH and RH side rear trunk garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace)
  8. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  9. Remove the clips (x6) that attach the rear wall load support to the vehicle.
  10. Remove the LH crush can bracket. See Trim - Crush Can - Rear Trunk - LH (Remove and Replace).
  11. Remove the push clip that attaches the LH soft trim pocket bracket to the vehicle, and then remove the bracket from the vehicle.
  12. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  13. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  14. Fold the LH 3rd row seat back into the down position.
  15. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  16. Release the clip that attaches the charge port manual cable release to the LH mid C-pillar zone bracket.
  17. Remove the screws (x2) and push clips (x4) that attach the LH mid C-pillar zone bracket to the vehicle, and then remove the bracket from the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket

Install

  1. Position the LH mid C-pillar zone bracket into the vehicle, and then install the screws (x2) and push clips (x4) that attach the bracket to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  2. Install the clip that attaches the charge port manual cable release to the LH mid C-pillar zone bracket.
  3. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  4. Fold the LH 3rd row seat back into the upright position.
  5. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  6. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  7. Position the LH soft trim pocket bracket into the vehicle, and then install the push clip that attaches the bracket to the vehicle.
  8. Install the clips (x3) that attach the LH crush can bracket to the vehicle.
  9. Install the clips (x6) that attach the rear wall load floor support to the vehicle.
  10. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  11. Install the LH and RH side rear trunk garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  12. Install the trunk carpet.
  13. Install the trunk tub floor insulator.
  14. Install the side trunk load floor. See Trunk Load Floor - Side (Remove and Replace)
  15. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  16. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  17. Close the LH rear door.