17/06/2022 13:15:13

Cover - Seat Back - 2nd Row Seat - LH (6 Seat) (Remove and Replace)

Correction code 13080112 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the driver seat forward.
  3. Open the LH falcon wing door.
  4. Move the LH 2nd row seat forward.
  5. Release the clips (x11) that attach the LH 2nd row seat seat back cover to the seat assembly, disconnect the electrical connector, and then remove the seat back cover from the seat assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the switch harness. Do not remove the trim from the seat assembly until the connector has been disconnected.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start from the top portion of trim and work downward.
  6. Remove the screws (x2) that attach the easy entry switch to the LH 2nd row seat seat back cover, and then remove the switch from the cover.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH2 screwdriver

Install

  1. Position the easy entry switch onto the LH 2nd row seat seat back cover, and then install the screws (x2) that attach the switch to the cover.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH2 screwdriver
  2. Position the LH 2nd row seat seat back cover onto the seat assembly, connect the electrical connector, and then secure the clips (x11) that attach the seat back cover to the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the lower datums and side tabs along the seat assembly, and then engage the clips fully.
  3. Move the LH 2nd row seat to the original position.
  4. Close the LH falcon door.
  5. Move driver seat to the original position.
  6. Raise the LH front window and close the LH front door.