2022-06-17
  Bracket - 2nd Row Floor Panel - Center (Without 2nd Row Bench Seats) (Remove and Replace)
    
    
     Correction code
    153038020.15
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
    Correction code
    153038020.15
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
  
Warning
This procedure is a DRAFT.
        Although it has been validated, Warnings and Cautions might be missing. Follow safety
        requirements and use extreme caution when working on or near High Voltage systems and
        components.
Remove
- Move the driver seat and front passenger seats fully forward.
- Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
- 
          Remove the 2nd row floor mat.
          
- Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
- 
          Remove the bolts (x2) that attach the
            center 2nd row floor panel bracket to the body, and then remove the bracket from the
              vehicle. 2.5 Nm (1.8 lbs-ft)TIpUse of the following tool(s) is recommended: 2.5 Nm (1.8 lbs-ft)TIpUse of the following tool(s) is recommended:- 10 mm socket
 
Install
- 
          Install the bolts (x2) that attach the
            center 2nd row floor panel bracket to the body. 2.5 Nm (1.8 lbs-ft)TIpUse of the following tool(s) is recommended: 2.5 Nm (1.8 lbs-ft)TIpUse of the following tool(s) is recommended:- 10 mm socket
 
- Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
- 
          Install the 2nd row floor mat.
          
- Install the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
- Restore the driver and front passenger seats back to their original position.