2026-03-25

Speaker - Pedestrian Warning (Remove and Replace)

Correction code 17541002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2026-03-25: Republished procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Remove the clip and release the tabs (x8) that attach the LH front wheel arch liner cover to the wheel arch liner, and then remove the cover from the liner.
  4. Release the connector lock, and then disconnect the pedestrian warning speaker electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not push down on red tab. Pull the red tab to disengage lock, and then pull again to release connector.
  5. Remove the screws (x3) that attach the pedestrian warning speaker to the vehicle, and then remove the speaker from the vehicle.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the pedestrian warning speaker into the vehicle, and then install the screws (x3) that attach the speaker to the vehicle.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Connect the pedestrian warning speaker electrical connector, and then engage the locking tab.
  3. Position the LH front wheel arch liner cover onto the wheel arch liner, and then secure the tabs (x8) and install the clip that attach the cover to the liner.
  4. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  5. Raise the LH front window and close the LH front door.