06/01/2023 13:13:41

Reinforcement - Inner - LH (Remove and Replace)

Correction code 15181302 1.44 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the trunk side trim bracket. See:
  2. Remove the 3rd row seat cushion, if installed. See Cushion - Seat - 3rd Row (Remove and Replace).
  3. Remove the bolts (x10) that attach the LH inner reinforcement to the body, and then remove the reinforcement from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bottom two bolts require improvising an 8 mm ratchet box-end wrench to turn the T40 socket.

Install

  1. Install the LH inner reinforcement to the body, and then install the bolts (x10) that attach the reinforcement to the body.
    27 Nm (19.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bottom two bolts require improvising an 8 mm ratchet box-end wrench to turn the T40 socket.
  2. Install the 3rd row seat cushion, if previously removed. See Cushion - Seat - 3rd Row (Remove and Replace).
  3. Install the trunk side trim bracket. See: