02/08/2022 11:44:44

Side Shield - Outboard - 2nd Row Seat - RH (5 Seat) (Remove and Replace)

Correction code 13085302 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the RH falcon wing door.
  2. Remove the RH 2nd row recliner lever. See Lever - Recliner - 2nd Row - LH (Remove and Replace).
  3. Release the clip that attaches the RH 2nd row seat outboard side shield to the seat.
    Tip: Use of the following tool(s) is recommended:
    • Clip pry tool
  4. Remove the bolt that attaches the RH 2nd row seat outboard side shield to the seat.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  5. Lift the RH 2nd row seat outboard side shield upwards to release the clips (x4) that attach the side shield to the seat, and then remove the side shield from the vehicle.

Install

  1. Starting with the top right corner of the RH 2nd row seat outboard side shield, position the side shield on the vehicle, and then install the clips (x4) that attach the side shield to the seat.
  2. Install the bolt that attaches the RH 2nd row seat outboard side shield to the seat.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  3. Install the clip that attaches the RH 2nd row seat outboard side shield to the seat.
  4. Install the RH 2nd row recliner lever. See Lever - Recliner - 2nd Row - LH (Remove and Replace).
  5. Close the RH falcon wing door.