17/06/2022 13:44:08

Ground Strap - Front Drive Unit (Remove and Replace)

Correction code 39011002 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  2. Disconnect LV Power. See LV Power (Disconnect and Connect).
  3. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  4. Remove the wiper module. See Wiper Module (Remove and Replace).
  5. Release the clip that attaches the electrical harness to the front drive unit LV harness bracket.
  6. Remove the captive bolt that attaches the ground strap to the front drive unit from the front drive unit.
  7. Remove the bolt that attaches the front drive unit ground strap to the LH casting, and then remove the strap from the vehicle.

Install

  1. Install the front drive unit ground strap to the LH casting, and then install the bolt that attaches the strap to the casting.
    15 Nm (11.1 lbs-ft)
  2. Install the captive bolt that attaches the ground strap to the front drive unit.
    5.5 Nm (4.1 lbs-ft)
  3. Fasten the clip that attaches the electrical harness to the front drive unit LV harness bracket.
  4. Install the wiper module. See Wiper Module (Remove and Replace).
  5. Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  6. Connect LV Power. See LV Power (Disconnect and Connect).
  7. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  8. Hold the LH and RH upper B-pillar buttons in the "Close" position to manually calibrate the LH and RH rear doors.