24/08/2022 10:59:07

Exterior Release Switch - Liftgate (Remove and Replace)

Correction code 11355602 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Remove the liftgate applique. See Applique - Liftgate (Remove and Replace).
  4. Open the liftgate.
  5. Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Remove the liftgate applique bracket. See Bracket - Applique - Liftgate (Remove and Replace).
  7. Remove the bolts (x2) that attach the liftgate exterior release switch to the liftgate.
    Tip: Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • Torx T30 socket
  8. Disconnect the liftgate exterior release switch connector, and then remove the release switch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the grey locking tab outwards to release the connector.

Install

  1. Position the liftgate exterior release switch on the vehicle, and then connect the release switch connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the connector is fully secured.
  2. Install the bolts (x2) that attach the liftgate exterior release switch to the liftgate.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
    • Torx T30 socket
  3. Install the liftgate applique bracket. See Bracket - Applique - Liftgate (Remove and Replace).
  4. Install the liftgate applique. See Applique - Liftgate (Remove and Replace).
  5. Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Close the liftgate.
  7. Raise the LH front window.
  8. Close the LH front door.