2025-04-21
End Cap - Instrument Panel - LH (2025+) (Remove and Replace)
Correction code
New
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Note
This procedure describes work that is
specific to 2025+ Model X.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
- Open the LH front door.
- Lower the LH front window.
-
Remove LH IP end cap
Note7x clips, 1x datum, Ensure clip at IP carrier is released fully before removal
-
Install LH IP end cap
Note7x clips, 1x datum
- Raise the LH front window.
- Close the LH front door.