2022-06-17

Latch - Liftgate (Remove and Replace)

Correction code 11355002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the liftgate cinching actuator from the vehicle. See Actuator - Cinching - Liftgate (Remove and Replace).
  2. Remove a small amount of the butyl patch, release the locking tab and Velcro strap, and then release the liftgate emergency release handle from the liftgate.
  3. Gently remove the liftgate emergency release handle Velcro patch from the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    The Velcro patch will be reused further in the procedure.
  4. Use a plastic trim tool to lift the emergency release cable, and then carefully remove the cable from the liftgate.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use caution when releasing the cable.
    Informational PurposesAn informational icon, calling your attention
    Note
    The cable is snug to the liftgate.
  5. Disconnect the liftgate latch electrical connector.
  6. Remove the bolts (x2) that attach the liftgate latch to the liftgate.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 socket
  7. Remove the liftgate latch from the liftgate, and then release the liftgate cinch cable from latch arm.
    Informational PurposesAn informational icon, calling your attention
    Note
    Handle carefully so as to not cause damage to the emergency release cable.

Install

  1. Install the liftgate cinch cable onto the liftgate latch.
  2. Position the liftgate latch onto the liftgate, and then install the bolts (x2) that attach the liftgate latch to the liftgate.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 socket
  3. Install the liftgate emergency release onto the mounting point on the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push down firmly on cable to properly seat it into the liftgate mounting point.
  4. Install the Velcro patch over the emergency release cable mounting hole on the liftgate as shown in image.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the Velcro is tight to the liftgate and properly centered, as emergency handle will be attached in the next step.
  5. Reapply the small butyl patch, move the liftgate emergency release handle into position, and then secure the locking tab and Velcro patch.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the locking tab is fully securing the release cable.
  6. Connect the liftgate latch electrical connector.
  7. Install the liftgate cinching actuator. See Actuator - Cinching - Liftgate (Remove and Replace).