Trim - Sill - Trunk (Remove and Replace)
Correction code 15244802 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Remove the LH and RH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
-
Remove and discard the bolts (x2), and
release the clips (x4), that attach the trunk sill trim to the body, and then remove the
trim from the vehicle.
Tip: Use of the following tool(s) is recommended:
- T25 socket
Install
-
Install the trunk sill trim to the
body, and then fasten the clips (x4) and install new bolts (x2) to attach the trim to
the body.Tip: Use of the following tool(s) is recommended:
- T25 socket
- Install the LH and RH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
- Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).