01/11/2024 14:10:28

Camera - Interior (Remove and Replace)

Correction code 17241602 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-11-01: Added note that Service Mode must be enabled prior to connecting the replacement camera.
  • 2023-12-21: Fixed errors.

Install

  1. Enable Service Mode. See Service Mode (Enable and Disable).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent potential damage to the replacement camera, Service Mode must be enabled prior to connecting the camera.
  2. Install the upper camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  3. Reset the Driver Assistance System (DAS).
    1. Unlock the vehicle gateway. See Gateway (Unlock).
    2. On the touchscreen Service Mode menu, touch Driver Assist > Cameras > Reset DAS.
    3. On the touchscreen Cameras diagram, confirm that the Reset DAS button is highlighted green and that all DAS components display a green status light.
      Informational PurposesAn informational icon, calling your attention
      Note
      Investigate and rectify any DAS components that display a red status light.
  4. HW4 cameras only: Run the camera connection test to update the new camera's firmware.
    Informational PurposesAn informational icon, calling your attention
    Note
    DAS Cameras are not CAN modules and cannot be updated via firmware reinstall or "Part Replacement Deploy".
    1. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
    2. Click on the Actions tab, search for "calibration mode", and then Run the DAS Enter Calibration Mode routine.
    3. Click on the Actions tab, search for "camera connection test", and then Run the routine that corresponds with the camera that was replaced (e.g., Left B-Pillar Camera Connection Test or Front Camera Connection Test).
      Informational PurposesAn informational icon, calling your attention
      Note
      The forward facing bi-camera assembly consists of two individual cameras that must be updated separately: Front Camera Connection Test and Fisheye Camera Connection Test. Make sure to update firmware on the cameras that were replaced.
      Informational PurposesAn informational icon, calling your attention
      Note
      If 2 versions of the same routine are displayed, Run the routine that contains "-SCRIPT" in the "Path" field.
    4. In the Camera Connection Test prompt, change the "Timeout" to "100", and then Run the routine.
      Informational PurposesAn informational icon, calling your attention
      Note
      This routine will update the camera's firmware and then confirm that the camera is connected.