2022-07-13

Sensor - Air Temperature - Duct - Footwell - LH (Remove and Replace)

Correction code 18107812 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect LV power. See LV Power (Disconnect and Connect).
  3. Remove the driver outboard footwell cover. See Cover - Footwell - Outboard - Driver (Remove and Replace).
  4. Remove the driver inboard footwell cover. See Cover - Footwell - Inboard - Driver (Remove and Replace).
  5. Remove the LH center console side carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).
  6. Remove the driver knee airbag assembly. See Knee Airbag - Driver (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the components from the airbag assembly after the assembly has been removed from the instrument panel.
  7. Disconnect the LH footwell duct air temperature sensor electrical connector, and then remove the sensor from the HVAC assembly.

Install

  1. Install the LH footwell duct air temperature sensor into the HVAC assembly, and then connect the electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the sensor is fully engaged and flush to the HVAC assembly.
  2. Install the driver knee airbag assembly. See Knee Airbag - Driver (Remove and Replace).
  3. Install the LH center console side carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).
  4. Install the driver inboard footwell cover. See Cover - Footwell - Inboard - Driver (Remove and Replace).
  5. Install the driver outboard footwell cover. See Cover - Footwell - Outboard - Driver (Remove and Replace).
  6. Connect LV power. See LV Power (Disconnect and Connect).
  7. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).