10/11/2022 08:15:56

Retractor - Seatbelt - 2nd Row - LH (5 Seat) (Remove and Replace)

Correction code 20056112 1.80 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).
  2. Remove and discard the bolt that attaches the LH 2nd row seatbelt retractor to the seat assembly, and then route the belt through the cover and over the belt guide to remove it from the assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of which slot is used by the seatbelt assembly in the frame during removal.
    Tip: Use of the following tool(s) is recommended:
    • T50 socket

Install

  1. Position the LH 2nd row seatbelt retractor into the seat assembly, route the belt over the guide and through the cover, and then install a new bolt that attaches the retractor to the seat assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the seatbelt into same guide noted during removal. Route the seatbelt before install fasteners.
    Tip: Use of the following tool(s) is recommended:
    • T50 socket
  2. Install the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).