2026-09-25

Retractor - Seatbelt - 2nd Row - Center (5 Seat) (Remove and Replace)

Correction code 20056312 1.86 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Air Bag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Remove

  1. Remove the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).
  2. Remove the center 2nd row seatbelt escutcheon bracket. See Bracket - Escutcheon - Seatbelt - 2nd Row - Center (5 Seat) (Remove and Replace).
  3. Remove and discard the bolt that attaches the center 2nd row seatbelt retractor to the seat frame, and then remove the retractor from the seat frame.
    Tip
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • Torx T50 socket

Install

  1. Position the center 2nd row seatbelt retractor on the seat frame, and then install a new bolt that attaches the retractor to the seat frame.
    45 Nm (33.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • Torx T50 socket
  2. Install the center 2nd row seatbelt escutcheon bracket. See Bracket - Escutcheon - Seatbelt - 2nd Row - Center (5 Seat) (Remove and Replace).
  3. Install the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).
  4. Enable service mode. See Service Mode (Enable and Disable).
  5. Perform a software reinstall. See Firmware Reinstall - Touchscreen.
  6. Exit service mode. See Service Mode (Enable and Disable).
  7. Raise the LH and RH front windows.
  8. Close all four doors.